Chemical resistant epoxy coating system KERAGUARD ADG220

1. Requirements:

2. Mixing:

3. Application steps

3.3. Applying the basecoat KERAGUARD ADG220

– Depending on the specific requirements of each system about number of coatings, number of MAT layers 300g (MAT 450g), the TISSUE mat or the thickness to have a plan of number of coatings for this step.
– Spread KERAGUARD ADG220 on the surface to be applied by short-hair roller.
– The mat layers must be pressed tightly on the surface by KERAGUARD ADG220, the MAT fiber mat must be applied first and then the TISSUE will be on the top.
– Note: The mat layer is pressed tightly on the surface as soon as the previous layers have not cured.
– Allow to dry at least 8 hours before applying the next steps.

3.4. Applying the topcoat KERAGUARD ADG220

– After the basecoat completely dries, it is important to check and fix the problems on the surface such as mat opening, air inside the coatings, etc.
– Remove the impurities on the surface.
– Spread the mixed KERAGUARD ADG220 on area to be applied by short-hair roller.
– Apply by roller several times and in 2 perpendicular directions, ensure the uniform of material on the surface.
– It is possible to apply multiple layers to ensure the completely coverage of the material.
– Allow to dry at least 24 hours before light traffic and 72 hours before using.