Epoxy Novolac coating system KERAGUARD VL100

1. Requirements:

2. Mixing

3. Application steps

3.3. Applying the basecoat KERAGUARD VL100

- Depending on the specific requirements of each system about number of coatings, number of MAT layers 300g (MAT 450g), the TISSUE mat or the thickness to have a plan of number of coatings for this step.
- Spread KERAGUARD VL100 on surface to be applied by short-hair roller.
- The mat layers must be pressed tightly on the surface by KERAGUARD VL100 sealant, the MAT fiber mat must be applied first and then the TISSUE will be on the top.
- Note: The mat layer is pressed tightly on the surface as soon as the previous layers have not cured.
- Allow to dry at least 8 hours before applying the next steps.

3.4. Applying the topcoat KERAGUARD VL100

- After the basecoat completely dries, it is important to check and fix the problems on the surface such as mat opening, air inside the coatings, etc.
- Remove the impurities on the surface.
- Spread the mixed KERAGUARD VL100 on area to be applied by short-hair roller.
- Apply by roller several times and in 2 perpendicular directions, ensure the uniform of material on the surface.
- It is possible to apply multiple layers to ensure the completely coverage of the material.
- Allow to dry at least 24 hours before light traffic and 72 hours before using.