– During application, workers must wear full labor protection (hat, clothes, shoes, glasses, mask, and gloves).

– Substrate moisture content < 15%.
– Maximum relative air humidity 80%.
– Do not apply in condition of excessive wind at the construction site.
– Limit the construction when the dew may arise or late afternoon.

– Using specialized mixer, approx. 300 rpm with a suitable mixing paddle.
– Mixing the material for a minimum of 2 minutes (may take a longer depending on weather conditions and equipment) to make the material is homogeneous throughout the container.

– Using specialized mixer, approx. 300 rpm with a suitable mixing paddle.
– Mixing the material for a minimum of 2 minutes (may take a longer depending on weather conditions and equipment) to make the material is homogeneous throughout the container.

– For wall or concrete surface, weak mortar layer and impurities on the surface must be removed.
– The wall surface is rubbed with sandpaper to remove weakly adhesive sand.
– The concrete surface needs to be roughened with a specialized machine before applying coating.
– For metal surface, it should be cleaned with water; rusted positions should be treated by mechanical preparation before coating.

– Using a specialized airless spray to apply primer to achieve the highest efficiency.
– The primer after application must ensure complete coverage of the surface to ensure the best advantages of material.
– Allow to dry 8 hours before patching, surface treatment or applying coatings.

– After the primer completely dries, applying KERA COOL COAT immediately.
– Using airless spray with suitable nozzle to achieve the best effect on heat resistant advantage of material.
– Spray the material on the surface to be applied with the amount of consumption as required.
– Surface after spraying must ensure the coverage and smooth of the material.
– Spray KERA COOL COAT into 2 coats, each coating is spaced at least 8 hours.
– 2 coats should be applied in 2 perpendicular directions, ensure the uniform of paint membrane and coverage of material.
– Allow to dry at least 24 hours before light traffic and 72 hours before using.

– Airless spray should be used to achieve the best effect. For application by spray a single line piston pump with a 20:1 ratio may be required, using a 0.015 inch tungsten nozzle tip. Spray 2 times in 2 perpendicular directions to help paint membrane has no pinholes.