Where should buy quality antistatic epoxy paint KERACOTE ESP300 with the best price?

Antistatic epoxy paint KERACOTE ESP300 is known as a product designed exclusively for electronic components factories. But in fact they are also used in many other types of manufacturing factories where are impacted by the magnetic field in the working environment. So what are other uses of the KERACOTE ESP300? What should be noted in the construction process? Let's find out with APT in the article below!

Antistatic epoxy coating KERACOTE ESP300

KERACOTE ESP300 is an antistatic, self-leveling epoxy system, with Conductive or Dissipative standards for heavy to medium loads concrete.

Advantages of antistatic epoxy coating KERACOTE ESP300

  • Meet EOS/ESD standards.
  • Maintain electrical conductivity throughout the system thickness.
  • Good wear and abrasion resistance.
  • General chemical resistance.
  • Gloss finishing.
  • Attractive color.

Uses of antistatic epoxy paint KERACOTE ESP300

  • Electronic components assembly and manufacturing factory
  • Explosive production factory.
  • Aircraft maintenance and assembly area.
  • Precision mechanical factory.
  • Hospital and sterile area.
  • Laboratory.

Applying process of antistatic epoxy paint KERACOTE ESP300

Step 1: Surface preparation

Before application, surface should be roughened with a specialized sanding machine. Then use a vacuum cleaner to clean the floor surface.

Step 2: Applying the primer

Primer KERASEAL PS60 is an important step in penetration and reinforcement surface to help connect coating with concrete floor. Use a short hair roller to apply evenly across the floor to ensure the next coat has the best adhesion. Allow to dry for at least 7 hours before light traffic or applying the next steps.

Step 3: Applying insulating primer PRIMERSEAL PS20

PRIMERSEAL PS20 is a product used as an insulating primer for antistatic control systems and conductive prime liners. Use serrated trowel in combination with spiked roller to break air bubbles. Allow to dry for at least 5 hours before applying the next steps.

Step 4: Stick copper tape and ground to earth ground

When sticking copper tape, the constructor should pay attention to the copper tape stick in square or checkered shape. The distance between the tapes should be <6m. The copper tape system is spread over the insulating primer surface and the earth point follows the approved design under next antistatic coatings. The contact point should be connected to the direct grounding system by the designed independent grounding system.

Step 5: Applying conductive layer KERASEAL PSD

Use paint brush and short hair roller to ensure full coverage. Usually one coat is enough, however, with place there are many holes or more honeycomb holes, a second coat can actually be applied during application. For favorable application, temperature must be kept above 20 ° C and ventilated fan must be maintained during application. The minimum time for next coating is 12 hours.


Step 6: Applying KERACOTE ESP300

Use serrated trowel to spread the mixed paint mixture on the surface to be applied. Then use spiked roller to break the air bubbles. Allow to dry at least 24 hours before light traffic and 72 hours before using.

Step 7: Acceptance of resistance and put into use

To perform this step a resistance meter is required. Resistance range should be from 10^4 – 10^6Ω or 10^6 – 10^9Ω depending on the factory requirements before application.

Where should customer buy quality antistatic epoxy paint KERACOTE ESP300 with good price?

KERACOTE ESP300 is antistatic epoxy coating that researched & developed by APT. We are the exclusive manufacturer and distributor in the market. So when buying directly at APT, we are committed to giving customers:

  • Genuine products, packing according to request
  • Best price in the market
  • Technical support during construction.

For more advice on antistatic paint products of APT, investors, factories please contact phone number 0904 339 299! We are always ready to serve customers.